Table of Contents
Advertisement
16
en | Installation
4.
5.
6.
7.
8.
9.
10. Install the conduit cover on the conduit plate with the bolt. Tighten the screw between
2023-02 | 02 |
Put the cable through the hole of the conduit plate.
Attach the conduit plate with the conduit plate adapter to the surface with a 5-6 mm
(0.2 inch) screw.
Remove the mounting plate from the box.
Mark the positions of the holes on the surface. The mounting plate has only one side
available for the conduit. Make sure to position it accordingly.
For standard installation, use the mounting holes marked with a B on the mounting plate.
For a different installation, for example for an installation on an electrical box, use
different mounting holes. For more information, refer to Installing the mounting plate,
page 14 .
Use 4 screws that are suitable for the surface and the type of installation. If needed for
the surface, drill 4 holes to fit plugs. Make sure that the plugs fit tightly. Use the
appropriate diameter drill to support 5 - 6 mm (0.2 inch).
Attach the mounting plate to the surface with 4 screws.
1.4 and 2 Nm (1 lbfft and 1.5 lbfft) with the TR20 Allen key.
Installation manual
FLEXIDOME multi 7000i IR
Bosch Security Systems B.V.
Advertisement
Table of Contents
