Installing The Handle; Filling The Engine With Oil - Toro Recycler 20374 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the mower housing
(Figure 3).
Important: Route the cables to the outside of
the handle knobs as you install the handle.
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you
removed in step 1.
G017314
Figure 3
2

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your mower does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Max. fill: 20 oz. (0.59 l), type: SAE 30 or SAE 10W-30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.
1. Move the mower to a level surface.
2. Remove the dipstick (Figure 4).
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Slowly pour oil into the oil fill hole, wait a few
minutes, and check the oil level on the dipstick by
wiping the dipstick clean and then inserting, but not
screwing in, the oil fill cap into the hole (Figure 4).
Note: Fill the engine crankcase with oil until the
dipstick indicates that the engine oil level is correct
as shown in Figure 4. If you overfill the engine with
oil, remove the excess oil as directed in Changing
the Engine Oil.
4. Install the dipstick and hand tighten it securely.
5
G017323
Figure 4
3. The oil level is too
low—add oil to the
crankcase.