Wall Thermostat Installation - Hotpoint AH12E07D Owner's Manual And Installation Instructions

Wall Thermostat Installation (Optional)
IMPORTANT
contact your local electrical contractor, dealer, or
distributor for assistance.
Thermostat Wire Routing
Thermostat wire is field supplied. Recommended wire
case any are damaged during installation. Thermostat
through, the wall sleeve. The wire should then be routed
behind the front panel to the easily accessible terminal
connector.
NOTE: Refer to thermostat installation instructions for
details on installing wall thermostat.
Wall Thermostat Enable
• Unit must be powered OFF to change dip switch
settings.
locations and functions.
49-5000684 Rev. 1
S5 S4 S3
UP (on)
Down (off)
Installation instruction for PTAC Thermostat
Remove the two screws as shown below and remove the
cover.
Terminal of PTAC Wall Thermostat (MODE A)
• Insert the wires from the wall thermostat into the correct
terminals according to manufacturers instructions.
Terminal
Compressor (Y)
Remove the 2 screws
Remove the covers
Thermostat connection
terminals
Designation