Table of Contents
Advertisement
Burner, Firebox and Control Knobs
11
'
Place burner assembly into firebox (A). Fasten the burner assembly to the firebox using 5mm fiber washers and #10-24 x 1/2"
machine screws.
'
Place firebox onto upper firebox supports with burner tubes below heat shield. Make sure burner tubes are correctly engaged . If
burner is not leveled from left to right, adjust the two screws attaching valve stems to control panel. Attach ignitor wire to ignitor (B) .
'
Attach firebox with #10-24x1/2" screws, 5mm fiber washers and #10-24 flange nuts (C).
'
Push control knobs onto valve stems (C).
Burner Assembly
A
Control Knob
18 • 466810608
34
27
27
34
27
Firebox
#10-24X1/2" Screw
Qty: 6
B
Valve
34
5mm Fiber Washer
#10-24 Flange Nut
Qty: 6
Burner Tube
Ignitor wire
C
13
13
Qty: 4
Advertisement
Table of Contents
