Table of Contents
Advertisement
NETWORK
NETWORK MENU
NETWORK INFORMATION
IP SETTING
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
DNS
DNS PRIMARY
DNS SECONDARY
MAC ADDRESS
EXECUTE
NETWORK SECURITY
INTERFACE
NETWORK PORT
APPLY
PING
IP ADDRESS
EXECUTE
RESET
Configures the monitor's network settings either automatically or manually.
When [AUTO] is selected, the IP address is automatically obtained from the DHCP server.
When [MANUAL] is selected, the network settings must be entered manually. Contact the Network
Administrator for this information.
NOTE:
Consult your network administrator for the IP address when [AUTO] is selected for [IP SETTING].
Set the IP address for the monitor connected to the network when [MANUAL] is selected for [IP SETTING].
Set the subnet mask data for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].
Set the default gateway for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].
NOTE:
Enter [0.0.0.0] to delete the setting.
Set the IP addresses of DHCP servers.
[AUTO]: The DNS server which is connected to the monitor will automatically assign its IP address.
[MANUAL]: Manually enter the IP address of the DNS server which is connected to the monitor.
NOTE:
Consult your network administrator for the IP address when [AUTO] is selected for [DNS].
Enter the primary DNS server settings of the network connected to the monitor.
NOTE:
Enter [0.0.0.0] to delete the setting.
Enter the secondary DNS server settings of the network connected to the monitor.
NOTE:
Enter [0.0.0.0] to delete the setting.
Shows the monitor's [MAC ADDRESS].
Executes the network information settings.
Individually enable or disable the networking component for monitor functions.
When performing the revision update of firmware over the network, please enable all settings.
Enables or disables the network function for controlling the monitor remotely.
When [DISPLAY] is disabled, these functions do not work: External Control, Mail, Daisy chain functions,
HTTP server, SNMP, Crestron, AMX, PJLink.
Disabling the [COMPUTE MODULE] setting disables the ability to control network connections and
monitors using [COMPUTE MODULE].
NOTE:
If you disable DISPLAY, monitor control in a daisy chain configuration is not available.
Please be aware of the impact in multi-monitor installations before disabling it.
Enables or disables the network port of the selected item. Disabling it closes the port and disables each
feature.
Apply the network security settings.
Confirm successful connection with the network by communicating with a preset IP address.
Sets an [IP ADDRESS] for sending [PING].
Checks a reply can be sent to the monitor or not from the [IP ADDRESS] by sending [PING].
Resets all NETWORK settings back to factory settings.
English−100
Advertisement
Table of Contents
