Table of Contents
Advertisement
Computer and USB Connection
Option 1: USB-C
1) Use a USB Type-C cable to the connect to USB-C output port of the external computer.
2) Press the Input key to switch to the USB-C channel.*
Option 2: HDMI
1) Use a USB cable to connect to the USB Type-B port on the monitor and to a USB Type-A port on the external computer.
2) Use an HDMI cable to connect to the HDMI output port of the external computer.
3) Press the Input key to switch to the HDMI channel.*
*1 If the input detection function is set to "ON", the terminals will switch automatically after connecting the computer (see
Connecting to a Computer with USB Type-C
• When using the USB-C port for video / audio, please use a SuperSpeed USB (USB 3.2 Gen 1) cable with USB compliance
logo.
• When using USB-C port for video / audio, please use a computer port with DP Alt Mode compliance logo.
• HDMI Alt Mode or MHL is not supported.
• When using computer battery charging (Power delivery), please use computer and cable with USB Power Delivery
compliance logo.
• Please allow several seconds for the monitor to recognize the USB signal. Do not disconnect or reconnect the USB cable
while the signal is being recognized.
Connecting to a Computer with HDMI
• Please use an HDMI cable with the HDMI logo.
• It may take a moment for the signal to appear after turning on the computer.
• Some display cards or drivers may not display an image correctly.
• If the monitorʼs power is turned on after a connected computer is turned on, sometimes an image is not displayed. In this
case, please turn off the computer then turn it on again.
Connecting a USB device
USB: USB downstream port (USB Type-A).
Connect USB devices such as a portable hard drive, USB flash drive, USB keyboard and mouse, Active pen charger, etc.
• Please make sure the connector shape and orientation is correctly aligned when connecting the USB device or cable.
• Please refer to the specifications page for power supply information (see
• When you use the USB port for power supply, please use a USB cable that supports 500mA.
• Do not bind the USB cable. It may trap heat and start a fire
Connecting to a Network
Synchronizes the time settings*, allows remote firmware updates*, provides remote control via commands, and connection to
the cloud.
• Connect the monitor to the network by using a commercially available LAN cable.
• Set the IP address (see
*: An Internet connection is required.
page
29).
1
1
page
English-24
page
38).
30).
Advertisement
Table of Contents
