Ambient Conditions; Operating Cycle; Installation - Marco 164 404 15 Instructions For Use Manual

ENG
TEMPERATURE:
WARNING: the above indicated temperature ranges are applicable to all components
of the pump and these limits must be respected in order to avoid any possible damage
or malfunctioning.
The pump has been designed for discontinuous use. Under conditions of high operating
pressures (eg. with closed or blocked outlet, excessive length of the delivery circuit and/or
excessive pressure due to accessories), it can be subjected to elevated stresses and
overheating and therefore should not be used for prolonged periods under such conditions.
TRANSPORTATION AND HANDLING
Due to limited weight and dimensions the pump does not require the use of any special
handling or lifting equipment. When handling manually, normal personal protective gear
should be worn (safety shoes with toe piece, etc.). The pump is carefully packed prior to
shipment. Upon receiving, the packaging should be inspected for damages and the pump
stored in a dry area.
It is recommended that the use of the pump be according to normative safety standards
and also as per the precautions listed below.
Check that there has been no damage to the pump during transportation or storage. Both
inlet and outlet ports should be carefully cleaned removing possible dust or residual
packaging material. Verify that the available electrical power supply corresponds to the
specification requirements.
The pump can be mounted in any position. Fix the pump utilizing suitable diameter
screws corresponding to the holes.

AMBIENT CONDITIONS

min.-10°C 14°F-max.60°C 140°F

OPERATING CYCLE

INSTALLATION

PRELIMINARY CHECKS
POSITIONING
RELATIVE HUMIDITY:
14
© S.p.A.
max. 90 %