Bleeding Of The Hydraulic Clutch - KTM SUPERMOTO FACTORY REPLICA 660SMS 2004 Owner's Manual

1
3
2
2
4
9
10
11

Bleeding of the hydraulic clutch*

To bleed the hydraulic clutch, demount the lower manifold and the right
main silencer. To demount, remove the 2 screws
cover.
Remove the manifold by detaching both springs
To remove the main silencer, remove screw
towards the back.
Remove the cover from the clutch's master cylinder.
6
Remove the screws and cover
Extract the oil from the reservoir.
9
Fill the bleeder syringe (available from your KTM dealer) with SAE 10
biodegradable hydraulic oil (e.g. Shell Naturelle HF-E15). Loosen the blee-
bk
der screw on the slave cylinder and attach the hose on the bleeder
syringe. Add oil with the bleeder syringe until the bubble-free oil starts to
bl
leak out of the hole in the master cylinder. Make sure the oil does not
overflow. Correct the oil level in the reservoir and mount the cover.
Biodegradable hydraulic oil is available from your KTM dealer in 50 ml cans.
!
– KTM
USES BIODEGRADABLE HYDRAULIC OIL FOR THE HYDRAULIC CLUTCH CONTROL
N
EVER MIX THIS OIL WITH MINERAL OIL
– O SAE 10
NLY USE BIODEGRADABLE HYDRAULIC OIL
E15)
TO FILL THE HYDRAULIC CLUTCH
.
BRAKE FLUID
1
and detach the side
2
and screw
4
and pull the main silencer off
7
including the rubber boot
CAUTION
.
( . . S
E G HELL
. N
EVER USE MINERAL HYDRAULIC OIL OR
3
.
25
8
. (see page 24)
!
.
N HF-
ATURELLE