Hilti DX 9-ENP Manual page 15

Information shown in the lower part of the display
Display
3.8 Bluetooth
®
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc and any use
®
of such marks by Hilti Corporation is under license.
3.8.1 Intended use
This product is equipped with a Bluetooth
and the transfer of settings and data based on Bluetooth
which the two Bluetooth-enabled products can communicate with each other over a short distance. This
product is designed to enable communication and data transfers between smart phones and Hilti gateway.
The tool can submit data attributes such as location of the receiving device, runtime, total application count,
application count during interval and timestamp of transfer. Information about the connectivity functions
offered can be found in the respective Hilti application (app) or in the operating instructions of the tool you
are using.
3.8.2 Data transmission via Bluetooth
The data transmission interval can vary depending on the available power source of the tool and the status of
the tool. The signal range may vary greatly depending on external conditions, including the receiving device
used. The Bluetooth range may be significantly weaker inside closed rooms and through metallic barriers
®
(e g. walls, shelving units, cases, etc.). Depending on ambient conditions, several transmission intervals may
be required before the tool is detected.
If the tool is not detected, check the following:
• Is the distance to the mobile terminal device too great?
→ Reduce the distance between the mobile terminal device and the tool.
3.8.3 Installing and setting up the app
In order to be able to use the connectivity functions, you first have to install the respective Hilti app.
(1.) Download the app from the corresponding app store (Apple App Store, Google Play Store).
You will require a user account on the corresponding app store to do this.
(2.) After starting the app for the first time, please either log in with your account or register.
(3.) The display of your mobile terminal device will show you all the subsequent steps required to connect
the tool to the mobile terminal device.
First, fully complete the tutorial for the app. This will give you a better overview of how the connection
is made and how the connectivity functions are used.
*2194400*
Explanation
At the lower left edge, a bar showing 1 to 7 segments indicates the
interval until the tool needs to be cleaned again.
In this case, cleaning will not be necessary for some time.
The 7 segments shown indicate that cleaning will be necessary
shortly.
The max. number of fasteners driven has been reached. The tool must
be cleaned.
The black square at the lower edge on the right indicates that demo
mode is active. In this case, the information in the display does not
reflect the actual status of the tool.
The Hilti Connect smartphone app can be used to deactivate the
demo mode. Demo mode is automatically deactivated after a period of
15 minutes.
Low Energy Module which enables the status checking of a tool
®
®
2194400
wireless technology, a data transfer system by
®
English 7