Craftsman 247.88780 Operator's Manual page 28

Craftsman Snow Thrower Model 247.88780
777I22139
777X43293
1. KEEP AWAY FROM ROTATING AUGER
CONTACT WITH AUGER CAN AMPUTATE
HANDS AND FEET.
1.) INSERT IGNITION KEY AND SNAP IN PLACE.
2. DISENGAGE CLUTCH LEVERS, STOP
ENGINE, AND REMAIN BEHIND HANDLES
2.) MOVE CHOKE CONTROL TO THE "CHOKE"
UNTIL ALL MOVING PARTS HAVE STOPPED
BEFORE UNCLOGGING OR SERVICING
MACHINE.
3. TO AVOID THROWN OBJECTS INJURIES,
NEVER DIRECT DISCHARGE AT BYSTANDERS
USE EXTRA CAUTION WHEN OPERATING ON
GRAVEL SURFACES.
4. READ OPERATOR'S MANUAL.
4.) MOVE CHOKE CONTROL SLOWLY TO THE
5.) TO STOP ENGINE: MOVE THROTTLE TO THE
777I23401
PRIMER
777S33636
CHUTE DIRECTIONAL CONTROLS
ADJUSTABLE
CHUTE TILT
ADJUSTABLE CHUTE
DISCHARGE
STARTING INSTRUCTIONS:
POSITION. PUSH PRIMER BUTTON 3x.
ROPE START: PULL SLOWLY UNTIL HARDER TO
3.)
PULL, THEN PULL RAPIDLY TO START. REPEAT
PRIMING IF NEEDED.
ELECTRIC START: DO NOT USE IN RAIN.
CONNECT POWER CORD AND PUSH STARTER
BUTTON. REPEAT PRIMING IF NEEDED.
"RUN" POSITION.
"STOP" POSITION.
777D14845
21" CLEARING WIDTH
179cc 4-Cycle OH V 179cc 4-Cycle OH V
ELECTRIC START ELECTRIC START
PARTS LIST
777S33731
CHOKE
28
777X43688
DO NOT
USE E85 OR FUEL
CONTAINING MORE
THAN 10% ETHANOL
777S33118
DANGER
AVOID INJU RY FROM
ROTATING AUGER -
KEEP HANDS, FEE T
AND CLOTHING AWAY .
777S32236
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL AL L
MOVING PARTS HA VE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN STICK TO
UNCLOG DISCHARGE CHUTE.