Rj45 Connector Pin Layout - Toshiba TOSVERT VF-AS3 Manual

3.2. RJ45 connector pin layout

The EtherCAT
VF-MB1/AS3, the shielding is connected to the drive ground. When you use VF-S15, the
shielding is connected to the grounding terminal of option adapter.
Use an STP (shielded twisted pair) Ethernet cable.
The transmission speed is detected automatically by the card (100 Mbps).
The card can operate in half duplex or full duplex mode, whether connected to a hub or a
switch and regardless of the transmission speed (100 Mbps).
Port IN (X1 L/A EtherCAT)
and Port OUT (X2 L/A EtherCAT)
8
* Fix a cable so that a communication connector may be not taken the weight of wire.
Cable specifications
• Minimum Cat 5e,
• Connector RJ45, no crossover cable
• Shield: both ends grounded
• Twisted pair cable
• Cable: 8 x 0.25 mm
• Use pre-assembled cables to reduce the wiring mistakes,
• Verify that wiring, cables and connected interfaces meet the PELV (Protective
Extra-Low Voltage) requirements.
• Maximum cable length = 100 m (328 ft)
®
unit is equipped with two shielded RJ45 connectors. When you use
Pin
1
2
3
4
5
6
1
7
8
2
(8 x AWG 22)
- 9 -
Signal Meaning
TX+ Ethernet transmit line +
TX- Ethernet transmit line -
RX+ Ethernet receive line +
-
-
RX- Ethernet receive line -
-
-
E6581818⑭