Replace The Console; Replace The Activity Zone Assembly (Model E3 Only) - Life Fitness E1 Service Manual

How To....

Replace the Console

Tools Required: Phillips Screwdriver
Estimated Repair Time: 15 Minutes
1. For model E1, proceed to step 2.
For model E3: remove the front lower
console support cover (See How To Re-
place the Accessory Tray on page16).
2. Remove and save the four Phillips screws
that secure the console assembly to the
console support bracket.
3. Note the location of the wire connections
to the console. This will simplify reassem-
bly.
4. Disconnect both wiring connections to the
console.
5. Install the new console in reverse order
using the screws removed and saved in
step 2.

Replace the Activity Zone Assembly (Model E3 only)

Tools Required: Short Phillips Screwdriver
Estimated Repair Time: 15 Minutes
1. Unplug the line cord from the wall outlet.
2. Remove and save the fi ve Phillips screws securing the
Activity Zone front to the back.
NOTE: There are two additional screws that mount the
Activity Zone back plastic to the upright. These do not
need to be removed.
3. Disconnect the cable connection at the Activity Zone.
4. Install the new Activity Zone front cover in reverse
order using the screws removed and saved in Step 3.
Console
Support Bracket
Phillips
Pan Head Screws (4)
Power to
TRACK+ CONSOLE
Console
Heart
Rate
Phillips Screws (5)
17
Console
GO CONSOLE
Power to
Ground
Console
Ground
Wire
Wire
Heart
Rate
Activity Zone