Dell VxRail VP-760 Manual page 43

Option
Workload Profile
CPU Interconnect Bus
Link Power Management
PCI ASPM L1 Link Power
Management
System security
In the BIOS, access System Security to view details.
1. To view the System Security screen, power on the system and press F2.
2. Click System Setup Main Menu, System BIOS, and then System Security.
The following table lists the system security details:
Option
CPU AES-NI
System Password
Setup Password
Password Status
TPM Information
The following table lists the TPM 2.0 security information:
TPM information
TPM Security
TPM Information
TPM Firmware
TPM Hierarchy
TPM Advanced
Settings
Description
NOTE: This option can be disabled when System Profile is set to Custom.
NOTE: When the C States option is set to Enabled in the Custom mode, changing the
Monitor/Mwait setting does not impact the system power or performance.
This option allows the user to specify the targeted workload of a server and allows
performance optimization that is based on the workload type. This option is set to Not
Configured by default.
Enables or disables the CPU Interconnect Bus Link Power Management. This option is set to
Enabled by default.
Enables or disables the PCI ASPM L1 Link Power Management. This option is set to
Enabled by default.
Description
Improves the speed of applications by performing encryption and decryption by using the Advanced
Encryption Standard Instruction Set (AES-NI). This option is set to Enabled by default.
Sets the system password. This option is read-only if the password jumper is not installed in the
system.
Sets the setup password. This option is read-only if the password jumper is not installed in the
system.
Locks the system password. This option is set to Unlocked by default.
Indicates the type of Trusted Platform Module, if present.
Description
NOTE: The TPM menu is available only when the TPM module is installed.
Allows you to control the reporting mode of the TPM. When set to Off, the presence of the TPM is
not reported to the operating system. When set to On, the presence of the TPM is reported to the
operating system. The TPM Security option is set to Off by default.
When TPM 2.0 is installed, the TPM Security option is set to On or Off. This option is set to Off by
default.
Indicates the type of Trusted Platform Module, if present.
Indicates the firmware version of the TPM.
Enables, disables, or clears the storage and endorsement hierarchies. When set to Enabled, the
storage and endorsement hierarchies can be used.
When set to Disabled, the storage and endorsement hierarchies cannot be used.
When set to Clear, the storage and endorsement hierarchies are cleared of any values, and then
reset to Enabled.
Specifies TPM Advanced Settings details.
Pre-operating system management applications 43