Table of Contents
Advertisement
REMOVAL OF ORIGINAL HEAD UNIT
Street Glide
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main
fuse before proceeding.
1. Remove three outer fairing bolts using a T27 Torx screw
driver. The three outer fairing bolts are located below the
windshield. Remove the windshield, store it and the screws
removed in a safe place for re-installation later.
TIP: Reinstalling the center screw after removing the
windshield will prevent the outer fairing from falling during
the next step. A few turned by hand will be su cient.
2. Remove four inner fairing bolts using a T27 Torx screw driver. The four inner fairing bolts are locate
adjacent to each turn indicator mounting bracket and below/adjacent to each speaker. Store these
screws in a safe place for re-installation later.
3. While straddling the front wheel fender, grasp the outer fairing, remove the center outer fairing
bolt from the previous step, then gently pull the fairing apart from the bike. With the fairing slightly
pulled away from the bike, disconnect wire harness for the headlamp and any other accessories. Lay
the fairing on a protected flat surface to prevent damage.
4. Remove upper support bracket. Removal of the
upper support bracket requires removing 11 screws:
4.1) remove four 5/32 allen screws
attaching the bracket to each speaker
enclosure (1)
4.2) remove two T25 screws attaching the
bracket to the inner fairing adjacent to
the gauge cluster (2)
4.3) remove four T25 screws attaching the
bracket to the head unit chassis (3)
4.4) remove one T25 crew attaching the
bracket to the media compartment (4)
2
1
4
5
Installation
3
Advertisement
Table of Contents
