Changing Sampling Frequencies And Bit Depths With Dante Controller - Tascam SB-16D Owner's Manual

5 Audio routing
Route the audio channels of the transmitting and receiving
devices that you want to connect here.
Click the intersection of the channels you want to connect
on the matrix to connect them.
NOTE
While pressing the computer keyboard Ctrl key, click the "-" at
the intersection of device names to connect all connectable
channels at once.
Changing sampling frequencies and bit
depths with Dante Controller
Double-click a device name on the Network View screen to open
the Device View screen.
On this screen, you can set and monitor conditions related to
devices on the Dante network.
Click the Device Config tab to open the page where you can
change the sampling frequency, bit rate and other settings of
the device selected in 1 shown in the illustration below.
1 Device name
This is the name of the device that can have its settings
changed in the current Device View.
2 Change device name
Edit the device name.
3 Sampling frequency
Set the sampling frequency.
4 Bit depth
Set the bit depth.
5 Latency setting
Set the latency.
ATTENTION
Changing the name of a device will clear audio routing
settings. For this reason, we recommend changing device
names to names that are easy to identify before setting audio
routings.
28
TASCAM SB-16D