Sony BDP-S1000ES Connecting Manual page 7


Internet Settings - Automatic Registration(WPS)
To automatically add the player (as a client device) to your wireless home
network, make sure your access point (a wireless router) is WPS-enabled or
supports Wi-Fi Protected Setup and locate the WPS button (actual
or virtual) on the access point. To register the player,
you will be requested to press this button in the next step.
Start
Press ENTER to start.
Press and hold the WPS button on the
wireless LAN router until the indicator on
the router starts to blink.
The message "Access point registration is
complete. " appears.
"Proxy Server" screen:
Select "Do not use" (unless your Internet service
provider has a specific proxy server setting), and
press ENTER.

Internet Settings - Network Connection Diagnostics
Perform network connection diagnostics?
Diagnostics cannot be stopped midway.
Network connection diagnostics can also be performed under "Setup".
Perform
Do not perform
Network Connection Diagnostics show
you if your networks are set up correctly.
Select "Perform, " and press ENTER.
Press ENTER when "Network connections
are correct. " appears.
If an error message appears, follow the on-
screen instructions.
For further details, visit the following
website and check the FAQ contents:
http://www.sony.com/blurayupdate
 Notes
 If the player does not detect a wireless LAN
router, wait a moment, then repeat from step 3.
 In some cases, depending on the security of
the wireless LAN router, it may not be
possible to use Wi-Fi Protected Setup (WPS).
In this case, follow the on-screen instructions,
and change the settings of the router.

Internet Settings - Complete Settings
Settings are complete.
List of settings
Connection Method Wireless
Wireless LAN Setting Method Automatic registration
SSID AP_for_BDP
Security Setting WPA2-PSK (AES)
WPA Key ********
IP Address Settings Auto Acquisition
IP Address 192.168.011.002
Finish
Press ENTER when "Settings are
complete. " appears.
Wi-Fi Setup is finished.
 Tip
If an error message appears in the network
diagnostic results, check the message. Then, set
the network settings again or perform the
network diagnostic again.