Water Pump; Water Pump; Breakaway Switch; Water Pump Access Locations - Airstream Trade Wind Owner's Manual

Breakaway Switch

1� Pin
2� Breakaway Switch
To prevent corrosion within the breakaway switch, pull
the pin out and spray the inside of the switch through
the hole with an electric contact cleaner (such as Spra-
Kleen). Applying a drop of light household oil on the pin
and the groove near the base of the pin will allow the
pin to operate freely. Immediately reinsert pin. Perform
this procedure every 90 days.
WARNING
Allow no more than 20 to 30 seconds pin
separation as damage to brake magnets may
occur.
2024 Trade Wind

Water Pump

Water Pump Access Locations

The water pump and strainer are accessible by pulling
outward on the right-hand side of the bottom hinged-
panel on the face of the wardrobe. The vent and
flexible ducting will move along with the panel. The
water pump is behind/under the ducting, which can
be moved out of the way or disconnected from the
backside of the louver vent if needed.

Strainer Cleaning

Locate the strainer housing (on the water line leading
to the water pump inlet). Remove the transparent
bowl (turn counterclockwise), and carefully pull out
the strainer/screen. Clean and rinse with water (use
a household detergent if necessary). Reinstall the
strainer and bowl, being careful not to damage the
seal. The bowl collects sediment and should be
positioned under the housing as depicted above.
Check for leaks prior to resuming normal operation.
Maintenance
8-11