Table of Contents
Advertisement
HANDLING THE UNEXPECTED
4. Take the tool case (tray) or bag out of the cargo
area. Take out the jack handle bar and wheel nut
wrench.
5. Unscrew the wing bolt, then remove the spacer
cone. Remove the spare tire.
6. Place the compact spare tire (wheel side up)
under the vehicle body, near the tire that needs
to be replaced.
7. Loosen each wheel nut about one turn using the
wheel nut wrench.
124 |
Models with tool case
Tool Case
Spare Tire
Models with tool bag
Tool bag
Setting Up the Jack
1. Place the jack under the jacking point closest to
the tire to be changed.
2. Turn the end bracket clockwise (as shown in
the image) until the top of the jack contacts the
jacking point. Make sure that the jacking point
tab is resting in the jack notch.
3. Raise the vehicle, using the jack handle bar and
the jack handle, until the tire is off the ground.
WARNING
The vehicle can easily roll off the jack, seriously injuring anyone underneath.
Follow the directions for changing a tire exactly and never get under the
vehicle when it is supported only by the jack.
The following instructions must be followed to use the jack safely:
• Use the jack provided in your vehicle. Other jacks may not support the weight
("load") or fit the jacking point.
• Do not use the jack with people or luggage in the vehicle.
• Do not use while the engine is running.
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the jack.
HANDLING THE UNEXPECTED
Jacking Points
Jacking Point
Jack
handle
Wheel nut
bar
Wrench as jack handle
| 125
Advertisement
Table of Contents
