Table of Contents
Advertisement
INSTRUMENT PANEL
Condition Indicators
These indicators may require you to perform an action.
Parking brake
U.S.
Release the parking brake before driving. You will hear a beep if you drive
with it not fully released.
Canada
Seat belt reminder
Make sure seat belts are fastened for you and all passengers. The indicator
blinks and beeps sound continuously if you or your front passenger has not
fastened your seat belts when you begin driving. If the indicator remains on
after seat belts are fastened, see your dealer.
Door/hatch open*
A door or the hatch is not closed. A beep sounds if open while driving.
Low fuel
Refuel as soon as possible. If the indicator blinks, there is a problem with the
fuel gauge. See your dealer.
Low tire pressure*
Stop in a safe place, check tire pressures, and inflate tire(s) if necessary.
The indicator also appears if the system has not been calibrated (see page
120).
Washer fluid level**
The washer fluid is low. Refill the washer fluid (see page 140).
System message*
When a condition or malfunction indicator comes on, a message also
appears on the Driver Information Interface. Check the display for more
information. Press the display/information button on the steering wheel to
clear the message.
Maintenance Minder*
Scheduled maintenance for your vehicle is due.
Immobilizer/security system
Your key or remote transmitter cannot be recognized by the vehicle. If the
indicator blinks, you may not be able to start the engine. Turn the vehicle
off, remove the key from the ignition*, press and hold the brake pedal, and
restart the vehicle. If it continues to blink, there may be a problem with the
system. See your dealer.
Canadian models: To reset the immobilizer system, follow the steps above
after the battery has been disconnected.
26 |
CVT models
MT models
On/Off Indicators
These indicators remind you when an item is on or off.
*if equipped
**Canadian models
Brake press
You must press the brake pedal before activating the electric parking brake
or automatic brake hold. If the indicator blinks, automatic brake hold is
canceled during operation. Immediately press the brake pedal.
Shift indicators*
Upshift or downshift when the arrow comes on, for better efficiency.
Vehicle Stability Assist (VSA) OFF
Comes on when you turn off VSA while driving in +R mode (see page nn).
VSA off
VSA engaged (blinking)
CRUISE MAIN* on
CRUISE CONTROL* on
ACC* on
CMBS* off
LKAS* on
Turn signals/hazards on
INSTRUMENT PANEL
Fog lights* on
High beams on
Exterior lights on
ECON mode* on
Automatic brake hold on
Automatic brake hold
U.S.
activated
Canada
Auto High-Beam* on
*if equipped
| 27
Advertisement
Table of Contents
