Chapter 5 Uefi Setup Utility; Introduction; Entering Bios Setup - ASROCK NUC BOX-1360P/D5 User Manual

Chapter 5

5.1 Introduction

ASRock Industrial UEFI (Unified Extensible Firmware Interface) is a BIOS utility
which offers tweak-friendly options in an advanced viewing interface. The UEFI
system works with a USB mouse and offers users a faster, sleeker experience.
This BIOS utility
startup, record hardware parameters of the system,
The battery on the motherboard supplies the power needed to the CMOS when the
system power is turned off, and the values configured in the UEFI utility are kept in
the CMOS.
Please note that
tion or boot failure. We strongly recommend that you do not alter the UEFI default
configurations or change the settings only with the assistance of a trained service
person.
If the system becomes unstable or fails to boot after you change the setting,
clear the CMOS values and reset the board to default values.
manual for instructions.

5.1.1 Entering BIOS Setup

You may run the UEFI SETUP UTILITY by pressing <F2> or <Delete> right
after you power on the computer; otherwise, the Power-On-Self-Test (POST) will
continue with its test routines. If you wish to enter the UEFI SETUP UTILITY after
POST, restart the system by pressing <Ctl> + <Alt> + <Delete>, or by pressing the
reset button on the system chassis. You may also restart by turning the system off
and then back on.
This setup guide explains how to use the UEFI SETUP UTILITY to configure all
the supported system.
Settings and options may vary owing to different BIOS release versions or CPU
installed. Please refer to the actual BIOS version of the motherboard you purchased
for detailed screens, settings and options.
26
UEFI SETUP UTILITY
can perform the Power-On Self-Test (POST) during system
inadequate BIOS settings may cause system instability, mulfunc-
The screenshots in this manual are for reference only.
load operating system, and so on.
See your motherboard
try to
UEFI