Electronic Pilot Ignition Wiring - MHSC B-Vent Series Manual

BBV, SBV Series Natural Vent Gas Fireplaces

ELECTRONIC PILOT IGNITION WIRING

Do not connect 110-120V AC to the Re-
mote Wall Switch. The appliance will
malfunction or destroyed.
REMOTE WALL SWITCH
Position the wall switch. Do not extend beyond the 15' of wire.
OPTIONAL DC REMOTE SYSTEMS
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote in-
structions supplied with the remote.
1. Plug in remote connector wire to remote receiver.
2. Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection
to the switch. Figure 18
3. Mount remote control receiver at junction box (for your wall switch).
18
Figure 19 -
Electronic Ignition System Wiring Diagram
ELECTRICAL INSTALLATION
FP2027
62D4037