Table of Contents
Advertisement
Check before starting
For safety reasons follow these recommendations!
•
Check the blade to ensure that no cracks have formed at
the bottom of the teeth or by the centre hole. The most
common reason why cracks are formed is that sharp
corners have been formed at the bottom of the teeth while
sharpening or that the blade has been used with dull
teeth. Discard a blade if cracks are found.
•
Check that the support flange is not cracked due to fatigue
or due to being tightened too much. Discard the support
flange if it is cracked.
•
Ensure the locking nut has not lost its captive force. The
nut lock should have a locking force of at least 1.5 Nm. The
tightening torque of the locking nut should be 35-50 Nm.
•
Check that the blade guard is not damaged or cracked.
Replace the blade guard if it is exposed to impact or is
cracked.
•
Check that the trimmer head and trimmer guard are not
damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or are
cracked.
•
Never use the machine without a guard nor with a
defective guard.
•
All covers must be correctly fitted and undamaged before
you start the machine.
20 –
English
All manuals and user guides at all-guides.com
STARTING AND STOPPING
Starting and stopping
WARNING! The complete clutch cover and
!
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
Always move the machine away from the
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury. The safety distance
is 15 metres.
Cold engine
Ignition: Set the stop switch to the start position.
Choke: Set the choke control in the choke position.
Air purge: Press the air purge diaphragm repeatedly until fuel
begins to fill the diaphragm. The diaphragm need not be
completely filled.
Warm engine
Ignition: Set the stop switch to the start position.
Choke: Set the throttle to the start position by moving the
choke control to the choke position and then returning it to its
original position.
Advertisement
Table of Contents
