Toro 136-2881 Installation Instructions

Ballast kit, groundsmaster 3500, 4500, or 4700 series 27in cutting units

Download this manual

Ballast Kit

Groundsmaster

Model No. 136-2881

This product contains a chemical or chemicals known to the State of California to

Safety

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of potential

damage. Replace any decal that is damaged or missing.

1. Height-of-cut settings

8111 Lyndale Avenue South

Bloomington, MN 55420

3500, 4500, or 4700 Series 27in Cutting Units

WARNING

CALIFORNIA

Proposition 65 Warning

cause cancer, birth defects, or reproductive harm.

121–3627

Form No. 3410-901 Rev A

Installation Instructions

Original Instructions (EN)

Printed in the USA

decal121-3627

Page 1 Form No. 3410-901 Rev A Ballast Kit Groundsmaster ® 3500, 4500, or 4700 Series 27in Cutting Units Model No. 136-2881 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Ballast plate Slotted screw Install the ballast plates. Flange nut Height-of-cut decal Installing the Ballast Plates Important: The ballast kit should be installed only when the UHMW front roller wheels are installed on the cutting unit.