Table of Contents
Advertisement
19.1 Malfunctions
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up and "Demo
mode is switched on"
appears in the dis-
play.
The appliance does
not start and "Cook-
ing compartment too
hot" appears in the
display.
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
The interior lighting
does not work.
Maximum operating
time reached.
Cause and troubleshooting
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your room or other appliances are working.
▶
Electronics fault
Briefly disconnect the appliance from the power supply by switching off the fuse.
1.
Reset the basic settings to the factory settings.
2.
→ "Basic settings", Page 14
There has been a power cut.
Implement the settings for the initial configuration.
▶
→ "Carrying out the initial configuration", Page 10
Malfunction
Call
▶
→ "Customer Service", Page 23.
Different causes are possible.
Check any notifications that appear in the display.
▶
→ "Displaying information", Page 11
Device is in demo mode.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
1.
the fuse box off and back on again.
Switch off demo mode within three minutes in the
2.
→ "Basic settings", Page 14.
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
The cooking compartment is too hot for the selected dish or type of heating.
Allow the cooking compartment to cool down and start again.
▶
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 14
The cleaning function locks the appliance door;
Allow the appliance to cool down until
▶
The childproof lock locks the appliance door.
Use the
button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 13
You can switch off the lock in the basic settings.
→ "Basic settings", Page 14
The halogen lamp is defective.
Change the oven light bulb.
▶
→ "Replacing the oven light bulb", Page 22
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
To continue operation, switch off the appliance with
1.
Then use
to switch on the appliance and set the required operation.
2.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
lights up in the display.
goes out in the display.
first.
Troubleshooting en
21
Advertisement
Table of Contents
