Hardware Description; Front View - Watchguard XTM 850 Hardware Manual

Hardware Specifications

Hardware Description

Front View

The front of the device.
A close-up of the front right side of the device.
LCD indicator panel
Device status information appears on the LCD screen. Press the buttons below the screen to change
the information that appears on the screen.
LCD console buttons
Press the LCD console buttons to see status information and start recovery procedures. To boot the
device in safe mode, press and hold the down arrow button when you power on the device.
For detailed information about the LCD indicator panel and the LCD console buttons, see "Use the
LCD Interface" on page 10.
Power ( )
When the device is powered on, the power indicator is green.
Arm/Disarm
When the device is armed, this indicator is green. When the device is disarmed, this indicator is red.
Storage (
When there is activity on the hard drive or the compact flash, this indicator is yellow.
Serial port
An RJ45 connector for the serial interface. is located to the right of the LCD screen. You can connect
to this serial interface to log in to the Fireware XTM command line interface.
For more information about the command line interface, see the current Fireware XTM Command Line
Interface Reference.
Dual USB interfaces
Connect a USB storage device to use for USB backup and restore, or to store a support snapshot.
For more information about USB functions, see the current WatchGuard System Manager Help or
Fireware XTM Web UI Help.
4
)
WatchGuard XTM 800 Series