Table of Contents
Advertisement
TC-32B
3.29
Single direction positioning function (G60)
Command format
X, Y, Z, A, B, C:
Coordinate of end point for G90 and travel amount for G91
Start point
Operation is reset.
When the above command is executed, the axis moves from the end point for the preset travel
amount, and then moves to the end point.
G60 is a one shot command and the axis travel path is the same as that for G00.
The travel amount is set for the user parameter.
1)
Single direction positioning is not performed for the Z-axis during a canned cycle, or the
XY-axes when they are moving for the preset amount of shift in the G76 and G87 cycles.
2)
Single direction positioning is not performed for any axis that does not have the travel
amount set for the parameter.
3)
Single direction positioning is performed even when 0 is specified for the travel amount.
4)
An error will occur when G60 is used during tool compensation.
2004/01/22
G60 X_Y_Z_A_B_C_
Command value of the axis for which single direction
positioning is performed.
End point
Travel amount
3 - 57
Chapter 3 Preparation Function
;
Single stop does not
Start point
Stop
eTCOMNCPR3.doc
3
eNCPR3.25.ai
Advertisement
Table of Contents
