Log; Debug Log Module; Debug Log Setting - Cisco ATA 191 User Manual

Configure Features
Field Name
Call Back Ring
Cfwd Ring Splash Len
Cblk Ring Splash Len
VMWI Ring Splash Len:

Log

The ATA allows you to record incoming, outgoing, and DHCP lists for various events that occur on your
network. The Incoming Log displays a temporary list of the source IP addresses and destination port numbers
for the incoming Internet traffic. The Outgoing Log displays a temporary list of the local IP addresses,
destination URLs/IP addresses, and service/port numbers for the outgoing Internet traffic.

Debug Log Module

Use the Administration > Log > Debug Log Module page to enable and configure logging.
• As a best practice, we recommend that you enable logging only when needed, and disable logging when
• In this page, you can select the modules which you want to see debug messages in all severity levels.

Debug Log Setting

If Debug Log Server is enabled on the Administration > Log > Debug Log Server page, the ATA will send
the debug messages to one server.
Enter the settings as described below. After making changes, click Submit to save your settings, or click
Cancel to redisplay the page with the saved settings.
Table 10: Debug Log Setting
Field
Debug Log Size
Description
-
Default setting: 7
-
Default setting: 0
-
Default setting: 0
-
Default setting: 0
you finish the investigation. Logging consumes resources and can impact system performance.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter User Guide for Multiplatform Firmware
Description
Enter the maximum size of the log file in kilobytes. Valid values are
from 128 to 1024.
Usage Guidelines
Allows you to select from one of 8
different ringtones for call back
notifications
Enter the length of the ring when a
call is forwarded, from 0 – 10
seconds.
Enter the length of the ring for the
call back notifications, from 0 – 10
seconds.
Enter the length of the ring for your
voicemail notifications, from 0 – 10
seconds.

Log

19