Hunter 53310 Installation Manual page 9

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x2
Ceiling Bracket Downrod
Assembling the Light
2
2 of 6
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Partially install two of the light kit screws
found in the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Note:
Fan style may vary.
Hanging Fan Wiring
2 of 6
Light Kit Screw
bag
hardware bag. Align the
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the last light kit screw. Tighten all
three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Press the globe and globe
keeper flush against the metal
plate. Thread the light pull chain
through the hole in the center of
the finial cap and thread the fan
pull chain through the hole in the
side of the cap. Finally, thread
only the light pull chain through
the hole in the finial and screw
the finial onto the threaded rod.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades Light
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
ON
8
Glass/Bulbs