Specifications - LG DLE1001 Series Owner's Manual

36

SPECiFiCATiONS

Before calling for service (cont.)
Problem
CHECK FILTER • Lint filter is almost clogged or
light is on full.
during the
drying cycle
TM
FLOW SENSE • Ductwork is too long or has too
many turns/restrictions.
indicator
• Significant blockage of the
shows four
ductwork due to lint buildup or
bars during the
debris.
drying cycle
• The appliance has detected a
or the display
restriction in the external dryer
shows "d80"
venting.
after drying.
The display • The duct work is about 90%-95%
shows blocked.
"d90", "d95" ("d90" or "d95" error code
displayed 2 hours only)
• House exhaust system blocked.
SPECIFICATIONS
Tm
Dryer models
Description
Electrical requirements*
Gas requirements*
Dimensions
Net weight
Drying capacity
- Normal cycle
Possible Causes
DLE1001* DLg1002*
Dryer
Please refer to the rating label regarding detailed information.
NG 4-10 / inches WC
1
2
LP: 8–13 inches WC (Gas Models only)
27" (W) X 28 /
15
16
68.6 cm (W) X 73.4 cm (D) X 102 cm (H), 127.5 cm (D with door open)
Electric : 119 lb (54kg) Gas : 121 lb (55kg)
IEC 7.3 cu.ft. (22.5 lb/10.2 kg)
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
POWER button will turn off the display.
• Do not use the dryer until the exhaust system has
been cleaned and/or repaired. Using the dryer with a
severely restricted exhaust is dangerous and could result
in a fire or other property damage.
• Check the outside dryer vent while the dryer is operating
to make sure there is strong airflow.
• If the exhaust system is extremely long, have it repaired or
rerouted.
• Keep the area around the dryer clean and free of clutter.
• Check vent hood for damage or lint clogging.
• Make sure the area around the vent hood is clear.
" (D) X 40 / " (H), 50 / " (D with door open)
3 1
16 4
Solutions
TM