Table of Contents
Advertisement
2
Safety and prevention
2.1
Introduction
The burners have been designed and built in compliance with
current regulations and directives, applying the known technical
rules of safety and envisaging all the potential danger situations.
It is necessary, however, to bear in mind that the imprudent and
clumsy use of the equipment may lead to situations of death risk
for the user or third parties, as well as the damaging of the burner
or other items. Inattention, thoughtlessness and excessive confi-
dence often cause accidents; the same applies to tiredness and
sleepiness.
It is a good idea to remember the following:
The burner must only be used as expressly described. Any
other use should be considered improper and therefore dan-
gerous.
In particular:
it can be applied to boilers operating with water, steam, diather-
mic oil, and to other uses expressly named by the manufacturer;
the type and pressure of the fuel, the voltage and frequency of the
electrical power supply, the minimum and maximum deliveries for
2.2
Safety warnings
The dimension of the boiler's combustion chamber must respond
to specific values, in order to guarantee a combustion with the
lowest polluting emissions rate.
The Technical Service Personnel will be glad to give you all the
information for a correct matching of this burner to the boiler.
2.3
Basic safety rules
Children or inexpert persons must not use the appliance.
Under no circumstances must the intake grids, dissipation
grids and ventilation vents in the installation room be cov-
ered up with cloths, paper or any other material.
Unauthorised persons must not attempt to repair the appli-
ance.
It is dangerous to pull or twist the electric leads.
Cleaning operations must not be performed if the appliance
is not disconnected from the main power supply.
Do not clean the burner or its parts with inflammable sub-
stances (e.g. petrol, alcohol, etc.). The cover must be
cleaned with soapy water.
Do not place anything on the burner.
Do not block or reduce the size of the ventilation vents in the
installation room.
Do not leave containers and inflammable products or com-
bustible materials in the installation room.
20035274
Safety and prevention
which the burner has been regulated, the pressurisation of the
combustion chamber, the dimensions of the combustion cham-
ber and the room temperature must all be within the values indi-
cated in the instruction manual.
Modification of the burner to alter its performance and desti-
nations is not allowed.
The burner must be used in exemplary technical safety con-
ditions. Any disturbances that could compromise safety must
be quickly eliminated.
Opening or tampering with the burner components is not
allowed, apart from the parts requiring maintenance.
only those parts detailed as available as spare parts by the
manufacturer can be replaced.
WARNING
This burner must only be used for the application it was designed
for.
The manufacturer accepts no liability within or without the con-
tract for any damage caused to people, animals and property due
to installation, adjustment and maintenance errors or to improper
use.
6
GB
The manufacturer guarantees safety and proper
functioning only if all burner components are intact
and positioned correctly.
Advertisement
Table of Contents
