Ariens IKON-X Operator's Manual page 26

1. Remove hardware retaining L-bracket to
battery bracket and reinstall hardware
into L-bracket hole nearest curved edge.
See Figure 18.
Figure 18
See Figure 19.
2. Place battery on battery tray so terminals
are positioned nearest right side of unit.
3. Install battery bracket over battery and
onto bolts in battery tray.
4. Reinstall L-bracket onto bolt and secure
with flange nut.
5. Secure remaining battery bracket end to
battery tray with original flange nut.
6. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
7. Return seat to operating position.
2
1. Negative Battery Terminal
2. L-Bracket
Figure 19
1
Install U1 Battery
1. Remove factory battery. See Remove
Battery on page 23.
2. Remove hardware from L-bracket and
secure L-bracket to battery bracket. See
Figure 20.
3. Place U1 battery in battery tray so
terminals are positioned toward the front
of unit.
4. Install battery bracket over battery and
onto bolts in battery tray. Secure with two
flange nuts. See Figure 21.
1. Positive Battery Terminal
2. Negative Battery Terminal
5. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
6. Return seat to operating position.
EN - 24
Figure 20
1
2
Figure 21