Watchguard XTM 810 Hardware Manual page 7

All interfaces are on the front of the device.
From the left, the indicators and connectors are:
Network interfaces — XTM 810, 820, 830
XTM 8 Series devices have a total of 10 network interfaces. The network interfaces have standard RJ45
connectors and are labeled 0, 1,2, 3...9.
Network interfaces — XTM 830-F (not shown)
The four network interfaces on the left have fiber connectors and are labeled 0,1,2, 3. The six
interfaces on the right have standard RJ45 connectors and are labeled 4, 5, 6, 7, 8, 9.
Indicators for RJ45 interfaces
At the top of each labeled RJ45 interface, there is a pair of indicators. The indicator at the left of the
interface is the activity indicator for that interface. The indicator at the right shows the connection
speed for that interface.
Indicator
Activity (upper left)
Connection Speed
(upper right)
Activity indicator on fiber interfaces
On the XTM 830-F, the network interfaces numbered 0–3 are fiber interfaces. Each fiber interface has
an activity indicator, but the location of the activity indicator is different from the location of the
activity indicator for interfaces 4–11.
Interface
0
1
2
3
Indicator Color
Yellow
Blinks
Hardware Guide
Indicator color
Yellow
Not lit
Blinks
(speed of blink increases as the
data flow increases)
Not lit
Green
Yellow
Indicator Location
At the top, between interfaces 0 and 1
At the bottom, between interfaces 0 and 1
At the top, between interfaces 2 and 3
At the bottom, between interfaces 2 and 3
Indicator Behavior
Power on, connection established
Data sent and received
Hardware Specifications
Interface Status
Power on, connection established
Power off, no connections
Data sent and received
Operates at 10 Mbps
Operates at 100 Mbps
Operates at 1000 Mbps
5