Table of Contents
Advertisement
GETTING STARTED
The Universal Mini Remote Control can be programmed to activate up to two products, such as a garage door opener, MyQ
controls, gate operator, or commercial door operator. Each button on the remote control works independently of the other and must be
programmed separately. The images throughout this manual are for reference only and your product may look different.
Garage Door Opener
You will need to locate the Program/LEARN button on your product before you start programming.
GARAGE DOOR OPENERS
The Program/LEARN button is typically located on the back or side panel
of your garage door opener. Newer garage door openers may have a
Program/Learn button located on the door control. Your Program/LEARN
button may have a different name (SMART button, SET button, etc.). For
help locating your Program/LEARN button refer to the Table of Contents
in this manual or contact your garage door opener manufacturer.
COMMERCIAL DOOR OPERATORS
The Program/LEARN button is typically located on the logic board of your
operator. Your Program/LEARN button may have a different name
(RADIO button, XMITTER button, etc.). For help locating your Program/
LEARN button contact your door operator manufacturer.
GATE OPERATORS
The Program/LEARN button is typically located on the control board of
your operator. Your Program/LEARN button may have a different name
(RADIO button, XMITTER button, etc.). For help locating your Program/
LEARN button contact your gate operator manufacturer.
Gate Operator
LED
Key Ring Holder
Top Button
Bottom Button
2
light
®
Commercial Door Operator
EXTERNAL RECEIVER
Some products do not
have a Program/LEARN
button. In this case, the
Program/LEARN button
will be located in an
external receiver. The
receiver will be located on
the product or mounted
nearby. Follow the
programming instructions
for an external receiver.
Advertisement
Table of Contents
