Table of Contents
Advertisement
EXTERNAL RECEIVERS
Programming to an External Receiver with a Program/LEARN Button
If using the Universal Mini Remote Control with residential door openers, the remote control must be used only with door
openers manufactured after 1993 that utilize photoelectric sensors. The photoelectric sensors are always located on or
STOP
near the bottom of the door track.
The Mini Remote Control comes pre-programmed to work with a Security+ 2.0
External receiver. Press and release the learn button, then press and hold the button on the remote control you would like
to use. If programming is not successful, proceed with the steps below.
The external receiver is typically located on the product or mounted near the product.
The images throughout this manual are for reference only and your product may look different.
1
Start with your garage door, commercial door, or gate
closed.
IMPORTANT: The remote will activate your door or gate during
programming. Ensure door or gate is clear of ALL obstructions.
3
Press and release the Program/LEARN button* on the
external receiver.
* Depending on your product, the Program/SMART/LEARN button may have a
different name (use the button for programming remote controls).
5
Wait for the door or gate to open, then press and release
either of the buttons on the remote to complete
programming.
2
Press and hold bottom button on the remote control until
the blue LED stays solid (approximately 15 seconds) then
release the button.
4
On the remote control, press and release the button that
you would like to program twice. The blue LED will blink
for up to 60 seconds.
Program/LEARN
Button*
6
Test the remote control by pressing the button you
programmed in step 4. If the garage door opener,
commercial door operator, or gate operator does not
activate, repeat the programming steps.
12
Chamberlain or LiftMaster branded
®
LED
LED
Bottom Button
Advertisement
Table of Contents
