Replacing The Display Assembly; Post-Requisites; Procedure - Dell Inspiron 11-3169 Service Manual

Replacing the display assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Post-requisites

1 Replace the wireless
2 Replace the battery.
3 Replace the base

Procedure

CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display.
1 Place the display assembly on the palmrest and keyboard assembly.
2 Align the screw holes on the display hinges with the screw holes on the
palmrest and keyboard assembly.
3 Replace the screws that secure the display assembly to the palmrest and
keyboard assembly.
4 Turn the computer over and close the display.
5 Slide the I/O-board cable into its slot on the system board and press
down the latch to secure the cable.
6 Route the antenna cable through its routing on the right speaker.
7 Slide the sensor-board cable into its slot on the I/O board and press
down the latch to secure the cable.
8 Slide the display cable into its slot on the system board and press down
the latch to secure the cable.
9 Adhere the tape on the display cable.
10 Align the screw hole on the display-cable bracket with the screw hole on
the system board.
computer. After working inside your
card.
cover.
After working inside your
61