Troubleshooting; Blown Fuse Or Circuit Breaker; Gate Does Not Open. Agitator Does Not Turn; Gate Does Not Open.or Is Sluggish Agitator Turns - Cornelius ENDURO-150 Installation Manual

Ice/beverage dispenser six valve
Hide thumbs Also See for ENDURO-150:
Table of Contents

Advertisement

Ice/beverage Dispenser Installation Manual
IMPORTANT: Only qualified personnel should service internal components or electrical wiring.
!
WARNING:
If repairs are to be made to a product system, remove quick disconnects from the applicable product tank,
then relieve the system pressure before proceeding. If repairs are to be made to the CO2 system, stop
dispensing, shut off the CO2 supply, then relieve the system pressure before proceeding. If repairs are to
be made to the refrigeration system, make sure electrical power is disconnected from the unit.
Should your unit fail to operate properly, check that there is power to the unit and that the hopper containsice. If the
unit does not dispense, check the following chart under the appropriate symptoms to aid in locating the defect.
Trouble

BLOWN FUSE OR CIRCUIT BREAKER.

GATE DOES NOT OPEN. AGITATOR
DOES NOT TURN.
GATE DOES NOT OPEN OR IS
SLUGGISH.
AGITATOR TURNS.

ICE DISPENSES CONTINUOUSLY.

SLUSHY ICE. WATER IN HOPPER.

BEVERAGES DO NOT DISPENSE.

BEVERAGES TOO SWEET.

BEVERAGE NOT SWEET ENOUGH

BEVERAGES NOT COLD (UNITS
WITH BUILT-IN COLD PLATE).
Publication Number: 91971RINS

TROUBLESHOOTING

Probable Cause
A. . Short circuit in wiring.
B. Defective gate solenoid.
C. Defective agitator motor.
A. No power.
B. Bent depressor plate (does not actuate
C. Defective dispensing switch.
A. Defective gate solenoid
B. Excessive pressure against gate slide.
C. Defective Rectifier.
A. Stuck or bent depressor plate (does not release switch).
B. Defective dispensing switch.
C. Improper switch installation.
A. Blocked drain.
B. Unit not level.
C. Poor ice quality due to water quality orice maker problems.
D. Improper use of flaked ice.
A. No 24 volt power to faucets.
B. No CO2 pressure.
A. Carbonator not working.
B. No CO2 pressure in carbonator.
C. Faucet brix requires adjusting.
A. Empty syrup tank
B. Faucet brix requires adjusting.
A. Unit standing with no ice in hopper -- no ice in cold plate
cabinet.
- 10 -
switch).
© 2004-2010, IMI Cornelius Inc.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents