Starting A Computer-To-Computer (Ad Hoc) Network Connection - NETGEAR WN121T User Manual

NETGEAR Next 300 Mbps Wireless USB 2.0 Adapter WN121T User Manual
You can use the ping utility to verify your wireless connection:
a. On the Windows taskbar click Start, and
then click Run.
b. Assuming the target PC is configured
with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1
OK.
c. This sends a continuous ping to the device with the 192.168.0.1 static IP address. The ping
response should change to "reply."
Figure 2-5
At this point the connection is established. For more information about using ping, see
http://kbserver.netgear.com/kb_web_files/N101453.asp.
Note: If you cannot connect, see
problems with accessing network resources, the Windows Client and File and
Print Sharing software might not be installed and configured properly on your
computers. Please see the link to
Addressing:" in Appendix

Starting a Computer-to-Computer (Ad Hoc) Network Connection

1. On the Settings tab page of the Smart Wizard, select or type the Network Name (SSID).
2. Select the Computer-to-Computer (Ad Hoc) network type.
and then click
Figure 2-4
"Removing the Software" in Chapter
"Internet Networking and TCP/IP
B.
v1.0, August 2006
1. Also, for
2-7