Table of Contents
Advertisement
Adjusting your monitor image
Using the direct access controls
Using the On-Screen Display (OSD) controls
2-6 C27-40 LCD Monitor User's Guide
This section describes the user control features used to adjust your monitor image.
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are coloured.
Table 2-1. Direct access controls
Icon
Control
Input change
Image Setup
Brightness
Low Blue Light
Main menu
The settings adjustable with the user controls are viewed through the On-Screen Display
(OSD), as shown below.
To use the controls:
1. Press
to open the main OSD menu.
2. Use
or
to move among the icons. Select an icon and press
If there is a sub-menu, you can move between options using
select that function. Use
3. Press
to move backwards through the sub-menus and exit from the OSD.
4. When un-OSD, press and hold
accidental adjustments to the OSD. When un-OSD, press and hold
unlock the OSD and allow adjustments to the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.
Description
Switches the video input source.
Activates automatic image adjustment.
Direct access to Brightness adjustment.
Press and hold for 3 seconds to enable/disable
Low Blue Light.
Open OSD main menu
or
to make adjustments. Press
for 10 seconds to lock the OSD. This will prevent
to access that function.
or
, then press
to
to save.
for 10 seconds to
buttons for 10
Advertisement
Table of Contents
