Adjusting Your Monitor Image; Using Direct Access Controls - Lenovo ThinkVision 27 3D User Manual

Adjusting your monitor image

Using direct access controls

2-3 ThinkVision 27 3D Flat Panel Monitor User's Guide
This section describes the control features to adjust your monitor images�
Direct access controls can be used when the On-Screen Display (OSD) is not displayed�
Icon Name
Enter key
Right key
Left Key
Down Key
Up Key
Input Source
DDC-CI
Power button
3D status indicator*
Volume down
Volume up
Description
• Press to open main menu while there is no any OSD on the
screen�
• Press to enter next level on main menu or sub menu, or move
backwards through the sub menus�
• Press and hold for 10 seconds to Lock/un-Lock all menu�
• Press to enter sub menu�
• Press to move backwards through the sub menus�
• Press to move lighting-indicator on main menu down to next one�
• Press to decrease current values on adjustment bar
• Press to increase current values on adjustment bar�
It is a shortcut for changing input signal while there is no OSD on
the screen or on power-saving mode�
Press and hold for 10 seconds to Enable/Disable the "DDC/CI"�
Turns the monitor on/off� White indicates power on� Orange indicates
standby/power saving mode�
When in 2D mode, the indicator light is off�
When in 3D mode, the white indicator light is on�
• Short press to decrease volume�
• Long press the volume to continuously decrease�
• Short press to increase the volume�
• Long press to keep volume up�