Self-timer
Shoots an image using the self-timer after a designated number of
seconds have elapsed since the shutter button was pressed. Use the
5-second/10-second self-timer when you are going to be in the picture,
and use the 2-second self-timer to reduce camera-shake caused by
pressing the shutter button.
1
Select
(Self-timer) by turning the drive mode dial.
• Turn the drive mode dial while holding down the drive mode dial lock
release button.
2
MENU
[Self-timer (Single)] desired mode.
The mode determines the number of seconds until a picture is taken
after the shutter button is pressed.
• The setting screen for [Self-timer Type] can be displayed by pressing
the Fn button.
Self-timer (Single): 10 sec
Self-timer (Single): 5 sec
Self-timer (Single): 2 sec
3
Adjust the focus and shoot the image.
The self-timer lamp flashes, a beep sounds, and a picture is taken after
the designated number of seconds have elapsed.
Hint
• Press the shutter button again to stop the count of the self-timer.
• Select a drive mode other than
to cancel the self-timer.
• Set [Audio signals] to [Off] to turn off the beeping sound during the self-timer
countdown.
• To use the self-timer in bracket mode, select
mode dial, then select MENU
[Selftimer during Bracket].
GB
82
(Camera Settings 1) [Self-timer Type]
(Self-timer) by turning the drive mode dial
(Bracket) by turning the drive
(Camera Settings 1) [Bracket Settings]