Recall - Sony a9 II Help Manual

• During bulb shooting, images tend to blur. It is recommended that you use
a tripod, a RMT-P1BT Bluetooth remote commander (sold separately) or a
remote commander equipped with a lock function (sold separately). When
using the RMT-P1BT Bluetooth remote commander, you can start bulb
shooting by pressing the shutter button on the remote commander. To stop
bulb shooting, press the shutter button on the remote commander again. To
use the other remote commander, use the model which can be connected via
the Multi/Micro USB terminal.
Note
• The longer the exposure time, the more noise will be visible on the image.
• When [ Long Exposure NR] is set to [On], noise reduction is performed
after shooting for the same duration that the shutter was open. You cannot
shoot while noise reduction is in progress.
• You cannot set the shutter speed to [BULB] in the following situations:
– [Auto HDR]
– [Picture Effect] is set to [Rich-tone Mono.]
– When [Drive Mode] is set to the following:
– [Cont. Shooting]
– [Self-timer (Cont)]
– [Cont. Bracket]
– [ Shutter Type] is set to [Electronic Shutter]
If you use the above functions when the shutter speed is set to [BULB], the
shutter speed is temporarily set to 30 seconds.
• If you set [Drive Mode] to [Cont. Shooting] and [
[Electronic Shutter] when the shutter speed is set to [BULB], the shutter speed
will be temporarily set to 1/8 second.
/
Allows you to shoot an image after recalling often-used modes or camera
settings registered with [
1
Set the mode dial to 1, 2, or 3 (Memory recall).
2
Press the center of the control wheel to confirm.
• You can also recall registered modes or settings by selecting MENU
 (Camera Settings 1)  [
GB
108

Recall

/ Memory] in advance (page 176).
/ Recall].
Shutter Type] to [Auto] or