Table of Contents
Advertisement
A3
ADJUST BLOWER MOTOR
Remove the screws holding the blower unit and
1
the screws securing the blower plate. Remove
the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
Blower Motor Screws
2 Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
Installation Instructions
Blower Plate
Blower
Motor
Screw
14
A3
ADJUST BLOWER MOTOR (cont.)
Fan Blades
Wires
Roll the blower so that fan blade openings are
3
facing the top of the oven. Place the blower back
into the opening.
Rotate 90°
Note: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to
the fan motor wiring, insert motor carefully such that
the fan motor wiring does not contact the microwave
power cord bracket.
WARNING:
Can cause injury or death. Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
Slide the blower plate back onto the microwave
4
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear
slot. Replace 3 screws.
Side Tab
Side Slot
Back of
Mircrowave
Back of
Mircrowave
Risk of Electric Shock.
Rear Tab
Rear Slot
Advertisement
Table of Contents
