Advertisement
flashes on the display. The appliance resumes operation
a few seconds after being placed in an upright position
again. See troubleshooting session. See the following
paragraph: "troubleshooting".
-
The appliance is fitted with a safety device which will
switch the appliance off in case of accidental overheating.
To reset, disconnect the plug from the power socket for a
few minutes, remove the cause of overheating then plug
the appliance in again. If this abnormal situation happens
several times, please contact the customer service.
Danger of burns!!
-
The use of an extension lead is not recommended, as
overheating of the extension lead may occur during the
operation of the heater.
The appliance complies with the following EC directives:
-
Low Voltage Directive 2006/95/EC and subsequent
amendments;
-
EEC Directive 2004/108 on electromagnetic compatibility
(EMC) and subsequent amendments;
Disposing of the appliance
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.
INTRODUCTION
Thank you for choosing a De'Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
Symbols used in these instructions
Important warnings are identified by the symbols below.
It is important to respect the warnings. Failure to respect the
warnings could lead to electric shock, serious injury, burns, fire
or damage to the appliance.
Important!
Failure to observe the warning could result in injury or damage
to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
DESCRIPTION
A
Power indicator light
B
ON/STAND-BY button
C
+/- adjustment buttons
D
MODE button (selects the operating mode)
E
"ECO plus" button
F
Timer button
General instructions
Remove the heater from the packaging. Check that neither the
heater nor the power cable has been damaged during transport.
Do not operate the heater if damaged. Remove all publicity
material present on the appliance. The appliance is suitable for
free-standing or wall-mounted usage. Do not assemble the feet
if wall-mounted.
Electrical connection
-
Before connecting the appliance to the current outlet,
check that the voltage indicated on the appliance rating
plate is the same as your electric plant and that it can stand
the power consumption (Watt) indicated by the labelling.
-
If more than one appliance is used at once, it is important to
ensure that the electric plant is able to support the power
required.
Mounting the feet
Turn the appliance upside down on a rug or soft surface in order
to prevent damaging the paint finish.
Fix the feet to the appliance with the nr. 4 screws B supplied
(see fig. 1), 2 screws for each foot.
Wall-Mounting Installation
The wall mounting kit contains:
4 metal brackets (A)
2 screws 4,8x13 PH (B)
4 screws 4,5x25 PH (C)
4 plastic anchors 6x30 (D)
Required tools for assembly and estimated assembly
time
Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes
Before installing the unit , make sure of the following:
a. The appliance must not be located directly beneath
a current outlet.
b. The plug and outlet must be easy to reach after
installation.
9
Advertisement
