Table of Contents
Advertisement
The dispays are used to indicate during setting of
parameters, the name and the value of them. Also are used
for menu indication and error codes displaing.
Memory Selection:
The memory function is designed to allow the operator to
save up to 9 specific welding procedures. This memory
button will have two functions:
1. Save memory settings
2. Recall memory settings.
Selecting Memory Functions:
button will allow the user to toggle between "saving" a
memory, "recalling" a memory or operating without using
a memory setting.
1. Pushing 1 time "M" icon, SAVE icon turned on.
2. Pushing 2 times "M" icon, RECALL icon turned on.
3. Pushing 3 times Icon and diplays turn off.
Saving Memory Settings:
In order to save process settings into a memory location it
is first necessary to press the memory button so that the
"memory save" icon is highlighted. Once highlighted, the
number on the screen will flash to indicate this number
can be changed by turning the control knob below, and
the voltage and amperage meters will say "MEM SET".
Once the desired memory location has been selected
using the control knob, pressing and holding the memory
button for 3 seconds will save the settings in that location.
During the 3 second hold period the "memory save" icon
will flash. After 3 seconds the displays will show "MEM
SAVE"
OPERATION:
1.) Press Memory button to highlight "Memory Save" icon;
2.) Turn Control Knob to Select memory location;
3.) Press and hold memory button for 3 seconds.
Recalling Memory Settings:
In order to recall process settings it is first necessary to
press the memory button so that the "memory recall" icon
is highlighted.
Once highlighted, the number on the
screen will flash to indicate this number can be changed
by turning the control knob below, and the voltage and
amperage meters will say "MEM RECL". Once the desired
memory location has been selected using the control
knob, pressing and holding the memory button for 3
seconds will recall the settings from that location. During
the 3 second hold period the "memory recall" icon will
flash.
After 3 seconds the displays will show "RECL
MEM"
OPERATION:
1.) Press Memory button to highlight "Memory Recall"
icon.
2.) Turn Control Knob to Select memory location.
3.) Press and hold memory button for 3 seconds.
English
Pressing the memory
Menu:
This unit permits an advance setting divided in 3 menu:
1.) Press and Hold
menu "GTAW".
2.) Press and Hold
menu "SMAW".
3.) Press and Hold
setup menu "SYS".
4.) Upon
entering
"GTAW","SMAW", or "SYS", menu progression is
accomplished by pressing
While moving backward is accomplished by pressing
5.) Changes to menu items will be accomplished by using
the Control Knob
6.) After an item is changed it will be saved if
is pressed.
7.) Each menu can be exited by pressing
12
for 5 seconds to access setup
for 5 seconds to access setup
+
for 5 seconds to access
one
of
the
three
menus
.
.
,
or
English
Advertisement
Table of Contents
