Kenmore Intuition BU4020 Use & Care Manual page 11

3. Press the Brushroll On/Off button for
cleaning carpets.
4. Once the vacuum is on, operate the
vacuum cleaner by tilting the wand back
towards you and the nozzle is flush with
floor surface.
NOTE:
The brushroll rotates when the
vacuum cleaner is in this position.
NOTE:
Brushroll does not rotate in
either mode when handle is in fully upright
position.
CAUTION
Do not allow the vacuum cleaner to
remain in one spot for any length of time
when the brushroll is turning. Damage
to carpet may occur.
5. Once you have completed vacuuming,
press the On/Off button again and
unplug the power cord from the power
outlet.
NOTE:
If the brushroll is turned on, first
press the Brushroll On/Off button to stop
the brushroll, and then press the On/Off
button to turn off the vacuum.
BAG FILL LEVEL INDICATOR
As the dust bag fills with dirt and debris,
an indicator near the wand can be used to
estimate the level of bag fill. Once all LEDs
are illuminated red, the bag should be
replaced. See page 18-19 for the dust bag
replacement instructions.
OPERATION MODES
Bag Fill Level
Indicator
One LED light (furthest
left), green continuous Lights progressively
Two LED lights, orange
continuous
Three LED lights,
orange continuous
Brushroll
On/Off
Four LED lights, red
Button
continuous
BRUSHROLL STATUS INDICATOR
Brushroll Status
Indicator
Green LED Lights
Red LED Lights
No LED Lights
- 11 -
CAUTION
Make sure the dust bag is replaced
when all LED lights begin to illuminate
red continuously. If not, the LED lights
will flash red. If the red flashing remains
after replacing the dust bag, check and
clean the air path as it is blocked.
Status
The brushroll is spinning and
working as it should.
There is a jam in the
brushroll area. Turn off and
unplug the vacuum, and
remove any blockages in
the nozzle.
The brushroll is off.
Brushroll
Status
Indicator
Bag Fill Level
illuminate to show
the bag is filling.
Replace the bag
when all LED lights
begin to illuminate red
continuously.