Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil CENTEC M2828-0 Operating Manual

3 Before use

3.1 Unpacking

ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of no
longer needed packaging material properly.

3.2 Selecting the proper nozzle

1
2
3

3.3 Assembly

A
1
4
A
5
16
4*
2 3
A B
B
1
B
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
The crevice nozzle and the furniture brush are included as accesso-
ries in the scope of delivery besides the floor nozzle (Fig. 2/1).
- Crevice nozzle (Fig. 2/2): Use this to vacuum dust from hard to
5*
reach places.
- Furniture brush (Fig. 2/3): Use this to vacuum dust off objects that
have sensitive surfaces.
*Optionally available (i.e. included in the scope of delivery depending
on model and features) are also:
- Parquet brush (Fig. 2/4*)
Its long bristles make it especially suitable for cleaning delicate sur-
faces (e.g. parquet and laminate floors).
- Turbo brush (Fig. 2/5*)
This has a rotating brush head and is most suitable for thoroughly
deep cleaning of carpets. The brushing also raises the carpet pile.
ATTENTION:
Our turbo brush serves solely to vacuum non-sensitive carpets,
runners, doormats, and the like. Do not clean any objects with the
turbo brush that you would not clean without a second thought with
a conventional brush. Therefore, do not clean furniture, or materi-
als with a delicate texture, nor any other high-quality or polished
substrates with the turbo brush. Otherwise material damage might
occur. If in doubt, refrain from using the turbo brush. In every
instance observe the instructions for care and cleaning of the
respective manufacturer.
2. Push the accessory bracket onto the telescopic tube as shown, or onto
the handle (Fig. 3/A).
3. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not con-
nected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
C
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.