Electrolux ETB4600C User Manual page 19

SpillSafe™ glass shelves
To remove the shelves, gently pull them forward
until the shelf comes clear of the shelf guides.
To return the shelf, make sure there is nothing
behind that may obstruct movement. Gently
push the shelf, into the cabinet and back into
position.
Freezer shelf
Remove the freezer shelf by lifting the catches
on the right and left underside of the shelf to
release the shelf then pull the shelf toward you.
Drawers fitted with telescopic slides
To remove the drawer for cleaning.
1. Empty food from the drawer.
2. Remove the drawer by pulling it forward
Insert into the slot at
the rear of the shelf
and lifting the front to unhook it from the
slides. Once you have removed the
drawer, ensure the slides are pushed back
so they are fully closed.
WARNING
Never close the door while the
telescopic slides are extended. This may
damage the slide and/or refrigerator or
cause the slide to become disengaged
from the refrigerator.
To replace the drawer:
1. Ensure the telescopic slides are pushed in
all the way.
2. Slide the drawer into place over the slides
and push the bin in until it stops.
3. Drop drawer into position.
Then engage into the
front of the shelf
Freezer bottom bin
To remove the bin, pull the drawer out until it is
open all the way then lift bin out from the front
of the bin. When refitting insert the rear of the
bin first then lower into position.
When replacing the bins after cleaning, we
recommend fitting the lower bin first.
CAUTION
Never close the door while the
telescopic slides are extended.
It may damage the slide and/or
the refrigerator or cause the slide
to become disengaged from the
refrigerator.
Twist and Serve Ice
Mounting the twist & serve dispenser to the
other side of the freezer.
NOTE: this is only possible on Top mount
models.
1. Remove the ice
bin and ice cube
tray. If the ice
tray assembly is
frozen to arriage,
simply squeeze
the tray and shelf
together to break the ice.
2. Before you remove the ice carriage,
remember to disengage it from the glass
shelf as it may result in damage to the
assembly.
3. Remove the centre runner by disengaging
it at the front of the shelf, and removing it
from the rear.
Insert into the slot at
the rear of the shelf
EN 19
Insert into the slot at Then engage into the
the rear of the shelf front of the shelf
Then engage into the
front of the shelf