Solid-State Drive And M.2 Solid-State Drive Bracket (For Selected Models) - Lenovo ThinkPad X13 Yoga 3 G User Manual

For access, do the following:
1. Disable the built-in battery. See "Disable the built-in battery" on page 27.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 28.
Removal procedure
Note: A Mylar film might cover the wireless WAN card. To access the wireless WAN card, peel off the film
first.
Note: During installation, ensure that you connect the cables with different colors to the corresponding
connectors on the card: the orange cable to the connector labeled ORANGE, and the blue cable to the
connector labeled BLUE.
M.2 solid-state drive and M.2 solid-state drive bracket (for selected
models)
Prerequisite
Before you start, read Generic Safety and Compliance Notices
Attention: If you replace a M.2 solid-state drive, you might need to install a new operating system.The M.2
solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for upgrade or repair. The M.2 solid-state drive is not designed for
frequent changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
30
X13 Yoga Gen 3 User Guide
and print the following instructions.