Gigabyte G1.Sniper 5 User Manual page 75

To further configure the RAID array, use the up or down arrow key to move the selection bar to select an item in
the right block of the screen and press <Enter> to display options (Figure 4). Set the required items in sequence.
Steps:
1. RAID Level: Select a RAID level.
2. Stripe Size: Select the stripe block size. Options include 32 KB and 64 KB.
3. Name: Enter an array name with 1~10 letters (letters cannot be special characters).
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Configure - > Select free disksCreate Virtual Disk
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* HDD 0: ST95005620AS
* HDD 1: ST95005620AS
Help
Virtual disk configurations.
ENTER: Select F10: Exit/Save ESC: Return
4. Next: After completing the settings above, move to Next and press <Enter> to begin creating the array.
When prompted to confirm whether to create this array, press <Y> to confirm or <N> to cancel (Figure 5).
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Configure - > Select free disksCreate Virtual Disk
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* HDD 0: ST95005620AS
* HDD 1: ST95005620AS
Create Virtual Disk
Do you want to create this virtual disk?
Help
Virtual disk configurations.
ENTER: Select F10: Exit/Save ESC: Return
RAID Level :
Max Size (MB) :
Stripe Size :
Quick Init :
Name :
Threshold(%) :
Next
Figure 4
RAID Level :
Max Size (MB) :
Stripe Size :
Quick Init :
Name :
Threshold(%) :
Next
Yes No
Figure 5
- 75 -
RAID 0
931.3GB
64KB
Yes
Default
100
RAID 0
931.3GB
64KB
Yes
Default
100
Configuring SATA Hard Drive(s)