Whipper Conversion - Cornelius 15 Gallon Single-Flavor Visual Display Dispenser J15 Training Manual

• Check whipper switch for adjustment. If moved too far forward, an air lock
may occur, thereby breaking the magnetic lock between whipper motor and
whipper chamber assembly.
To adjust whipper switch, loosen screw to the right of the switch. Slide switch in
slot to desired location.
NOTE: When switch is moved to the forward position (out towards operator)
whipper motor will come on with very little movement of the push handle.
When switch is all the way back (towards front panel) whipper motor will
not come on, even when the handle is pushed all the way back.

2.3 Whipper Conversion

1. Disconnect power.
2. Drain bowl.
3. Remove pinch tube, bowl, dispense lever, drip tray, switch cover plate, and
front panel.
4. Install washer and standoff into the whipper motor mounts on condensate tray.
5. Install whipper motor assembly and fasten with 3 keps nuts.
6. Wire according to diagram.
NOTE: Use existing cable clamps and wire ties provided to route wires away from
sharp edges and fan blade.
7. Attach new wiring diagram to new front panel.
8. Install new front panel with existing hardware.
9. Install switch cover plate with switch to condensate tray in front of whipper
motor assembly (use 10-32 x 1 1/4" screw and spacer).
10. Attach whipper decal on raised boss of condensate tray where whipper motor
was installed.
11. Replace bowl, new dispense lever, pinch tube, and whipper chamber assembly
and drip tray. When placing the whipper assembly into the bowl, assure that it
is located into the recess directly above the whipper decal. Then insert the 90°
elbow into the pinch tube.
12. Connect power, premix product, and add product to bowls.
© 2000, IMI Cornelius Inc.
Jet Spray (Cold) Training Manual
- 7 -